Assembling The Stop Switch; Assembling The Throttle - Husqvarna 525BX Workshop Manual

Safety equipment

6.6 Assembling the stop switch

Put all details in the both handle halves.
Make sure that all cables is fitted in the handle and
A
will not be clamped.
Make sure the stop switch and cables, throttle trig-
ger and cable are properly assembled.
Carefully put the handle together.
Fasten the 4 screws (A) that holding the handle in
place. Place the rubber cap in position.
Torque 2 ~ 2.5 Nm

6.7 Assembling the throttle

Check that the stopper on the throttle trigger is fit-
ted inside of the housing. B C
Figure (B) show correct position and figure (C)
shows incorrect position.
Check that the adjuster screw head of the throttle
cable is located outside of the slide guide.
8.5mm at first
Figure (D) show correct position and figure (E)
D E
shows incorrect position.
21
English -