Operation Procedure Using External Control - Panasonic LP-310 Operation Manual

1-5-2 Operation Procedure Using External Control

This section describes the basic operation procedures using the external control.
Flow Chart
■
1. External control using I/O connector
Turn ON the key switch on the power supply BOX of the laser marker.
• There are two modes, personal control mode and remote mode for this product.
The switching of the mode between personal control mode and remote mode is set with the
personal computer.
CHECK
When turning on the power supply of this product, the remote mode is activated.
OPEN manual shutter of laser marker head.
READY Output ON
•The trigger is ready for reception.
Transfer marking data from PC to laser marker.
Select file
•Select file No. using the external control.
READY Output ON
•The trigger is ready for reception.
Trigger Input ON
•The product starts marking.
Marking
* The procedure marked with
is performed by manual.
2. External control using RS-232C
43