Test Marking - Panasonic LP-310 Operation Manual

3-9

Test Marking

3-9-1 Test Marking

The test marking is performed in PC control mode from the PC.
•
When performing the test marking, set the shutter (guide indication switching lever) to "OPEN".
•
For some PC models, the dialog box below may be hidden behind the main screen of this
software. Do not perform any key operation (Enter, Space, etc.) in this state. Display the dialog
box in the front of the PC screen by clicking the software name (LP-310 setting software)
displayed on the Windows task bar or via keyboard operations ("Alt" + "F6", "Alt" + "Tab"), and
CHECK
click "Yes" to perform the test marking.
•
Note that in test marking, the file under editing is transferred to the head and overwritten to the
file with the same No. existing in the head.
1 "File" - "TEST"
2 Click
Select the operation from either "1" or "2" for performing the test marking.
When the shutter is set to "CLOSE", the dialog box indicating the shutter is in CLOSE state is appeared.
Click "OK" button, set the shutter to "OPEN", and perform either "1" or "2" operation again.
When the shutter is set to "OPEN", the dialog box "Start of printing" is appeared.
If the file No. under editing in PC is existed in the head, the following dialog box for checking whether the over-
writing is allowed or not is appeared. (If there exists no file with the same fine No. in the head, this dialog box
is not apperaed.)
When selecting "Yes" in the dialog box "Start of printing", the file is transferred and the test marking is started.
After ending the test marking, the "End of printing" dialog box is appeared.
Besides, the marking time is also displayed.
138
.