Operating Instructions Operation Manual Intelligent Feeder Check Unit NM-EJW2A Model No. Thank you for purchasing the intelligent feeder check unit. Before placing the machine in service, be sure to read the instruction manual for proper usage. After that, store it carefully and read it if necessary.
“Operation of this machine: This machine shall be operated by professional, specially trained operators. Regarding the training course, please contact Panasonic Factory Solutions Co., Ltd. or PFSE.” Machine was manufactured by: Panasonic Factory Solutions Co., Ltd. 441-13, Nagahasu, Tateishi-machi, Tosu-city, Saga, Japan...
Introduction This manual describes how to handle the intelligent feeder check unit. NOTICE For information on how to operate the intelligent feeders and how to set them onto the placement machine, refer to the Operation Manual for the tape feeders. NOTICE This manual describes how to handle the intelligent feeder check unit.
Safety precautions Be sure to observe The precautions that shall be observed in order to prevent an injury to the user or the other persons, and damage to property, are described as follows. The degrees of danger or injury, resulting from incorrect usage owing to failure to read an indication, are classified and described as follows.
Labels pasted on product for safety Warning labels The warning labels are pasted on this machine as follows. Follow the instructions on each label. If it has come off, place an order with us for it, referring to the Parts List; then, put a new one on a proper location.
Page 14
Labels pasted on product for safety Caution labels The warning labels are pasted on this machine as follows. Follow the instructions on each label. If it has come off, place an order with us for it, referring to the Parts List; then, put a new one on a proper location.
About storage management and handling This describes the precautions in the storage of the check unit. NOTICE In handling the check unit, be sure to observe the following matters. 1 Storage Precautions Avoid storing it in a high-temperature (40 degrees or over) and high-humidity place or a low-temperature (0 degrees or below) place.
Page 16
Avoid storing it in the place where oil or an organic solvent is splashed. Otherwise, rubber and resin parts may potentially be deteriorated and broken. EJW2A-AA Avoid bumping or knocking it down. Even if there is no damage on the surface, actions can be affected. EJW2A-AA EJW2A-E-OMA00-A04-00...
Page 17
Serial plate The serial plate indicating the product name (Model ID) and production number (Serial No.) of the machine is pasted on the following location. NM-EJW2A NM-EJW2A Actually, ∗ is replaced with a numeric value. EJW2A-AB EJW2A-E-OMA00-A04-01...