Laser Setting; Screen For Laser Setting - Panasonic LP-310 Operation Manual

3-6

Laser Setting

3-6-1 Screen for Laser Setting

The condition of the marking laser for marking a character string or CAD file is set on this screen.
1 "View" - "Set Laser"
2 Click
The "Laser Setting" dialog box is appeared by clicking either selecting "1" method or clicking "2" button
described above.
1
2
3
7
Item
1. Laser Power
2. Scan Speed
3. Line Width
4. Start Wait
5. End Wait
6. Marking Pitch
7. Marking Quality Sets the number of segments of the stroke at a
•
Even if the scan speed is doubled, the marking time is not reduced to a half.
•
If the scan speed is too high, the characters may be distorted. Check the symptom at the test
CHECK
marking beforehand.
126
.
Description
Sets the average output of the marking laser.
Sets max. transfer speed of the laser spot.
Sets the with of the stroke of the marked character.
Adjusts the timing for turning ON the laser at the
start point.
Adjusts the timing for turning OFF the laser at the
ending point.
Sets the density for marking a bold character.
curve part stepwise.
4
5
6
Setting Range
0.5 to 100.0 (Step: 0.5)
1 to 2000mm/s (Step: 1mm)
0.01 to 2.00mm (Step: 0.01mm)
50 to 150 (Step: 1)
50 to 150 (Step: 1)
0.00 to 2.00mm (Step: 0.01mm)
Rough to fine
11 steps