Built-Under A Continuous Worktop; Removing The Lid - Miele PG 8581 Operating Instructions Manual

Removing the
lid
Steam condenser
Securing to the
worktop
Venting the
circulation pump

Built-under a continuous worktop

To build the machine under a continuous worktop, the lid must be
removed as follows:
Unscrew both securing screws from the lid at the back of the

machine.
Open the door.

Unscrew the left and right fixing screws.

Lift the lid.

To avoid steam damage to the worktop, the protective foil supplied
(self adhesive 10 x 23" / 25 x 58 cm) must be applied underneath
the worktop in the area of the steam condenser.
To improve stability, the machine must be secured to the worktop
after it has been aligned.
Open the door.

Screw the machine to the continuous worktop through the holes in

the front trim on the left and right.
Please contact Miele to secure it at the sides to adjacent cabinetry.
 The gaps between a built-in machine and adjacent cabinetry
must not be filled with silicone sealant as this could compromise
the ventilation to the circulation pump.
Installation
125