Rear Wheel (For Non-Abs Models) - Yamaha MT09 Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
Rear wheel (for non-ABS
models)
WARNING
For the ABS model, have a Yamaha
dealer remove and install the wheel.
To remove the rear wheel
WARNING
6
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the axle nut.
1
1. Axle nut
2. Lift the rear wheel off the ground
EAU44802
according to the procedure on
page 6-39.
EWA14841
3. Remove the axle nut.
4. Fully loosen the locknut on each
side of the swingarm.
5. Turn the drive chain slack adjust-
ing bolts fully in direction (a) and
push the wheel forward.
EAU56701
EWA10822
1. Drive chain slack adjusting bolt
2. Locknut
6. Remove the drive chain from the
rear sprocket.
TIP
 If the drive chain is difficult to re-
 The drive chain cannot be disas-
7. While supporting the brake caliper
1 2
(a)
1. Wheel axle
6-41
move, remove the wheel axle first,
and then lift the wheel upward
enough to remove the drive chain
from the rear sprocket.
sembled.
bracket, pull the wheel axle out,
and then remove the wheel.
NOTICE: Do not apply the brake
after the wheel and brake disc
have been removed, otherwise
the brake pads will be forced
shut.
[ECA11073]
1