Rear Wheel (For Non-Abs Models) - Yamaha MT09 Owner's Manual

1
2
1. Brake caliper bolt
2. Brake caliper
4. Pull the wheel axle out, and then
remove the wheel.
To install the front wheel
1. Lift the wheel up between the fork
legs.
2. Insert the wheel axle.
3. Install the brake calipers by install-
ing the bolts.
TIP
Make sure that there is enough space
between the brake pads before install-
ing the brake calipers onto the brake
discs.
PERIODIC MAINTENANCE AND ADJUSTMENT
4. Lower the front wheel so that it is
on the ground, and then put the
sidestand down.
5. Tighten the wheel axle, the front
wheel axle pinch bolt and the
brake caliper bolts to the specified
torques.
Tightening torques:
Wheel axle:
65 Nm (6.5 m·kgf, 47 ft·lbf)
Front wheel axle pinch bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
Brake caliper bolt:
35 Nm (3.5 m·kgf, 25 ft·lbf)
6. Push down hard on the handlebar
several times to check for proper
fork operation.
6-40
Rear wheel (for non-ABS
models)
WARNING
For the ABS model, have a Yamaha
dealer remove and install the wheel.
To remove the rear wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the axle nut.
1
1. Axle nut
EAU44802
EWA14841
EAU56701
EWA10822
6