Engine Oil And Oil Filter Cartridge - Yamaha MT-09 Owner's Manual

Hide thumbs Also See for MT-09:
Table of Contents

Advertisement

Periodic Maintenance And Adjustment

Engine oil and oil filter cartridge

The engine oil level should be
checked before each ride. In addition,
the oil must be changed and the oil
filter cartridge replaced at the intervals
specified in the periodic maintenance
and lubrication chart.
To check the engine oil level
1.
Place the vehicle on a level
surface and hold it in an upright
position. A slight tilt to the side can
result in a false reading.
2.
Start the engine, warm it up for
several minutes, and then turn it
off.
3.
Wait a few minutes until the oil
7
settles, and then check the oil level
through the check window located
at the bottom-right side of the
crankcase.
TIP
The engine oil should be between the
minimum and maximum level marks.
1
2
1. Engine oil filler cap
2. Engine oil level check window
3. Maximum level mark
4. Minimum level mark
4.
If the engine oil is below the
minimum level mark, add sufficient
oil of the recommended type to
raise it to the correct level.
TIP
Check the O-ring for damage, and
replace it if necessary.
7-12
3
4
1. Engine oil filler cap
2. O-ring
To change the engine oil (with or
without
oil
filter
replacement)
1.
Place the vehicle on a level
surface.
2.
Start the engine, warm it up for
several minutes, and then turn it
off.
3.
Place an oil pan under the engine
to collect the used oil.
4.
Remove the engine oil filler cap,
the engine oil drain bolt and its
gasket to drain the oil from the
crankcase.
1
2
cartridge

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mtn850-a

Table of Contents