Quick Shift System - Yamaha MT-09 Owner's Manual

Special Features
Resetting the traction
system
The traction control system will
automatically disable when:
the front wheel or rear wheel
comes off the ground while riding.
excessive rear wheel spin is
3 detected while riding.
either wheel is rotated with the key
turned to "ON" (such as when
performing maintenance).
If the traction control system is
disabled, both the "
and the " " warning light will come on.
Should this occur, try resetting the
system as follows.
1. Stop the vehicle and turn the key
to "OFF".
2. Wait a few seconds and then turn
the key back to "ON".
3. The " " indicator light should turn
off and the system be enabled.
TIP
If the " " indicator light remains on
after resetting, the vehicle may still be
ridden; however, have a Yamaha
dealer check the vehicle as soon as
possible.
4. Have a Yamaha dealer check the
control
vehicle and turn off the "
warning light.
" indicator light
"

Quick shift system

The quick shift system (QS) allows
for
electronically-assisted
When the shift switch detects motion
in the shift pedal (page 4-14), engine
power
momentarily adjusted to allow the
upshift to occur.
TIP
3-3
full-throttle, clutch lever-less,
upshifts.
and drive torque
The quick shift system operates
when traveling at least 20 km/h
(12mi/h) with an engine speed of
2300r/min or higher, and only
when accelerating.
It does not operate when the
clutch lever is pulled.
are