Installing The Control Panel And Fuel Tank - Toro 30177 Operator's Manual

2
Figure 2
1. Mounting block
2. Shift lever
Installing the Control Panel
and Fuel Tank
1. Slide control panel over shift lever and under bottom
of rear frame (Fig. 3). Align fuel tank to top of rear
frame (Fig. 3).
Figure 3
1. Rear frame
2. Control panel
2. Secure control panel and fuel tank to rear frame with 4
bolts (5/16 x 7/8 in.), 4 lock washers (5/16 in.) and
washers (Fig. 4).
3. Slide hose clamp onto fuel line (Fig. 4). Push fuel line
onto fuel tank fitting and secure with hose clamp
(Fig. 4).
3
4
1
m–4762
3. Bolt, 1/4 x 2 in.
4. Washer
3
1
2
m–1716
3. Fuel tank
13
3
2
1
4
Figure 4
1. Bolt, 5/8 x 7/8 in.
2. Lock washer
3. Washer
4. Shift lever to second gear and check alignment of
lever in shifter plate slot. The clearance between top
and bottom of the shift lever should be equal (Fig. 5).
5. If clearance is not correct, remove lever and bend it
slightly to adjust (Fig. 2).
Note: Do not bend lever while attached to transmission
shaft or damage may occur.
6. Shift lever to neutral and check alignment of lever in
slot of shifter plate. The clearance on the sides of shift
lever should be equal (Fig. 5).
7. If clearance is not correct, loosen control panel and
adjust it side–to–side. Tighten the control panel.
1
4 4
3
Figure 5
nd
1. Shift lever, 2 gear
2. Control panel
6
5
m–1717
4. Fuel line
5. Hose clamp
6. Fuel fitting
2
Rear View
2
m–5458
3. Shift lever, neutral
4. Equal distance