Assembly; Loose Parts; Installing The Shift Lever - Toro 30177 Operator's Manual

Setup
Note: Determine the left and right sides of the machine
from the normal operating position.

Loose Parts

Note: Use the chart below to verify all parts have been shipped.
DESCRIPTION
Shift lever
Shift lever mounting bracket
Washer, 1/4 in.
Bolt, 1/4 x 2 in.
Fuel tank
Control panel
Bolt, 5/16 x 7/8 in.
Lock washer, 5/16 in.
Washer, 5/16 in.
Hose clamp
Upper handle
Flanged bolt, 3/8 x 1 in.
Flange nut, 3/8 in.
Screw self-tapping
Star washer
Wire tie
Rod fitting
Clevis pin
Washer, 1/4 in.
Hairpin cotter
Operator's Manual
Engine Operator's Manual
Parts Catalog
Registration card

Installing the Shift Lever

1. Align mounting block with flats of shaft on top of
transmission and slide onto shaft (Fig. 2).
Note: Do not remove rubber washer on transmission shaft.
QTY.
1
1
Installing the shift lever
1
1
1
1
4
Installing the control panel and fuel tank
4
4
2
1
4 Installing the upper handle
4
1
1 Installing the wire harness
1
2
2
Installing the control rods
2
2
1 Read before operating machine
1
1
1 Fill out and return to Toro
2. Align mounting hole in lever with mounting block on
transmission. Secure lever to transmission with 2 in.
(51 mm) bolt and washer. Torque bolt to 115 in.–lb.
(13 N.m).
12
USE