Table of Contents
Advertisement
WRITE MULITPLE EXT
WRITE VERIFY
WRITE DMA FUA EXT
WRITE DMA QUEUED FUA EXT
Note: 1. As defined in the ATA/ATAPI-6 standard.
Identify Drive Command
This command allows the host to receive parameter information from the drive.
When the command is received, the drive:
1. Sets BSY
2. Stores the required parameter information in the sector buffer
3. Sets the DRQ bit
4. Generates an interrupt
The host may then read the information out of the sector buffer. Parameter words in
the buffer are shown in Table 5-2.
Note: All reserved bits or words should be zeroes.
Table 5-1
Supported Commands
Command
ATA Bus Interface and ATA Commands
Command
Code
39h
3Ch
3Dh
3Eh
Maxtor DiamondMax 8S 40GB SATA
Feature
Register
Value(s)
5-5
Advertisement
Table of Contents
