Spare Wheel - Opel Combo 2011 Manual

5. Unscrew the wheel bolts.
If there are lock washers on the
wheel bolts, these must not be
removed.
6. Change the wheel.
7. Screw in the wheel bolts.
8. Lower vehicle.
9. Install the wheel wrench ensuring
that it locates securely and tighten
each bolt in a crosswise
sequence. Tightening torque is
110 Nm.
Alloy wheels: put wheel bolt cap
on and engage, inserting pin on
rear of wheel bolt cap into relevant
hole in wheel.
Alloy wheels with anti-theft lock:
Put wheel bolt cap on. Insert and
tighten antitheft lock.
10. Before installing the wheel cover,
clean the wheel around the
retaining clips. Valve symbol on
back of wheel cover must point
towards valve on wheel.
Align and engage wheel bolt cap
or wheel cover and wheel bolt
caps.
11. Stow the replaced wheel 3 121
and the vehicle tools 3 118.
12. Check the tyre pressure of the
installed tyre and also the wheel
bolt torque as soon as possible.
Have the defective tyre renewed or
repaired.

Spare wheel

Some vehicles are equipped with
a tyre repair kit instead of a spare
wheel.
The spare wheel can be classified as
a temporary spare wheel depending
on the size compared to the other
mounted wheels and country
regulations.
The spare wheel has a steel rim.
Use of a spare wheel that is smaller
than the other wheels or together with
winter tyres could affect driveability.
Have the defective tyre replaced as
soon as possible.
Vehicle care
The spare wheel is stored beneath
the floor.
1. Fully release the hexagon bolt in
the load compartment floor using
the wheel bolt wrench. Vehicle
tools 3 118.
2. Lift the spare wheel holder.
3. Unhook the catch and lower the
spare wheel holder.
Back to overview
127