Settings Page Definitions; Table 9: Settings Page Definitions - Grandstream Networks GXP2130 Administration Manual

SETTINGS PAGE DEFINITIONS

Settings  General Settings
Local RTP Port
Use Random Port
Keep-alive Interval
Use NAT IP
STUN Server
Public Mode
Settings  Call Features
Off-hook Auto Dial
Off-hook Timeout
Bypass Dial Plan Through Call
History and Directories
Disable Call Waiting
Disable Call Waiting Tone
Disable Busy Tone on Remote
Disconnect
GXP2130/GXP2140/GXP2160
FIRMWARE VERSION 1.0.5.18

Table 9: Settings Page Definitions

This parameter defines the local RTP port used to listen and transmit. It
is the base RTP port for channel 0. When configured, channel 0 will use
this port _value for RTP; channel 1 will use port_value+2 for RTP. Local
RTP port ranges from 1024 to 65400 and must be even. The default
value is 5004.
When set to "Yes", this parameter will force random generation of both
the local SIP and RTP ports. This is usually necessary when multiple
phones are behind the same full cone NAT. The default setting is "Yes"
Note: This parameter must be set to "No" for Direct IP Calling to work.
Specifies how often the phone sends a blank UDP packet to the SIP
server in order to keep the "ping hole" on the NAT router to open. The
default setting is 20 seconds. The valid range is from 10 to 160.
The NAT IP address used in SIP/SDP messages. This field is blank at
the default settings. It should ONLY be used if it's required by your ITSP.
The IP address or Domain name of the STUN server. STUN resolution
results are displayed in the STATUS page of the Web GUI. Only
non-symmetric NAT routers work with STUN.
Configures to turn on/off the public mode for hot desking feature. The
default setting is "No".
Configures a User ID/extension to dial automatically when the phone is
off hook. The phone will use the first account to dial out. The default
setting is "No".
If configured, when the phone is on hook, it will go off hook after the
timeout (in seconds). The default value is 30 seconds. The valid range is
from 10 to 60.
Enable/Disable the dial plan check while dialing through the call history
and any phonebook directories. The default setting is "No".
Disables the call waiting feature. The default setting is "No".
Disables the call waiting tone when call waiting is on. The default setting
is "No".
Disable the busy tone heard in the handset when call is disconnected
remotely. The default setting is "No".
GXP2130/GXP2140/GXP2160
ADMINISTRATION GUIDE
Page 42 of 87