Advertisement
3. Mark the points where the sides of the seat hit the drop base.
NOTE: Each point should be no more than 1 inch wide as shown in FIGURE 4.
4. Remove the seat from the drop base.
5. Notch the seat sides at the points determined in STEP 3. An electric knife works
best for this procedure.
6. Place the seat on the drop base at the desired position.
7. If necessary, repeat STEPS 4-6 until the seat sits flush on the drop base.
8. Reinstall the seat into the inner and outer covers. Refer to Removing/Installing
Seat Covers on page 4.
9. Reattach the seat onto the seating surface of the wheelchair. Refer to
Attaching/Removing Seat To/From Seating Surface on page 2.
Seat
FIGURE 4 Modifying Seat to Fit onto Drop Base
Seat Inspection and Cleaning
Inspection
DO NOT continue to use this product if any of the following problems as
described are discovered. Corrective maintenance can be performed at, or
arranged through, your equipment supplier.
Once a week, visually inspect all parts, including hardware, upholstery materials,
foams, and plastics for deformation, corrosion, breakage, wear and/or
compression.
InTouch™TargIT™
WARNING
6
1 inch Wide
1 inch Wide
Part No 1125097
Advertisement
