Avery Dennison Monarch 9462 Operating Instructions
Avery Dennison Monarch 9462 Operating Instructions

Avery Dennison Monarch 9462 Operating Instructions

Single-station
Hide thumbs Also See for Monarch 9462:

Advertisement

O P E R A T I N G
I N S T R U C T I O N S
The Monarch® 9462™ Single-Station Battery Charger
charges one 7.4V lithium-ion battery at a time for the
following printers:
Sierra Sport2™ 9460™
Sierra Sport3™ 9433™
Monarch® Pathfinder® Ultra® Silver 6032™
Monarch® Pathfinder® Ultra® Platinum 6039™
Pathfinder® 6057
You must charge a battery before using it.
Note:
Information in this document supercedes information
in previous versions. Check our Web site
(www.monarch.com) for the latest documentation and
release information.
TC9462OI Rev. AL 5/11
©2009 Avery Dennison Corp. All rights reserved.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Monarch 9462 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Avery Dennison Monarch 9462

  • Page 1 You must charge a battery before using it. Note: Information in this document supercedes information in previous versions. Check our Web site (www.monarch.com) for the latest documentation and release information. TC9462OI Rev. AL 5/11 ©2009 Avery Dennison Corp. All rights reserved.
  • Page 2 WARNINGS Use only a Monarch-qualified battery. The battery  could be damaged or explode if placed on a different charger. Do not charge non-rechargeable batteries in this  charger. Do not throw the battery in the trash. Dispose  according to your local regulations. Do not disassemble, short-circuit, heat above ...
  • Page 3 C h a r g i n g t h e B a t t e r y To charge the battery, insert the battery into the charger, with the ribbed end sticking out. Charging time can take up to three hours. It takes approximately 1 hour to reach the 80% level (where it is now usable).
  • Page 4 Troubleshooting When an error occurs, the Charging and Complete LEDs blink together. In this case, repeat the charging process. If the error still occurs, repeat the process with a new battery. If there is a still a problem after the second repeat charge, call Service. In between charges, remove the battery, wait for the lights to stop flashing, then re-insert the battery.

Table of Contents