Table of Contents
Advertisement
Device-Specific Configuration,
Follow these steps to download a file.
1.
From the Command List section of the Main Configuration screen (serial
configuration), press the Space Bar.
2.
Type download and press Enter to go to the Download a File screen.
Result: This screen displays the IP Address of the TFTP server and the name
of the file you wish to download.
3.
Press Enter to start downloading the file.
If the download is interrupted, do not reset the module or reboot the chassis. Close
the session, and then open a new TFTP session.
Port Configuration
The Prisma EtherLinX unit allows you to configure the ports via serial configuration
(you can also configure the ports via the PrismaView software). Type ports and
press Enter to be taken to the Port Configuration screen. In this screen you can
enable/disable ports, configure FiberAlert and Auto-Negotiation, etc.
Note: The following screen includes information for the unit's four downlink ports.
32
Continued
Continued on next page
4008226 Rev B
Advertisement
Table of Contents
