Advertisement
Pull the second paper tray (Tray 2) up until it stops. After
that, lift it slightly, then pull it out.
Pull out the first paper tray (Tray 1), and take the
screwdriver ( ) from the tray.
Note
Be sure to return the screwdriver to the paper tray after using
it.
Lock the paper bank and the printer with the screw.
Replace the second paper tray (Tray 2) into the printer.
TAPH210E
TAPP720E
TAPP031E
TAPH221E
Printed in Japan
Open the lower vertical paper feed cover on the right side
of the paper bank ( ). Hang the lock plate hook in the
hole inside ( ), and then fasten the plate with the knob
screw using your fingers.
Close the lower vertical paper feed cover.
Open the connector cover ( ), remove the tape that
holds the connector cable and attach the connector
cables ( ) as shown in the illustration.
Close the connector cover.
Note
Print a configuration page to confirm that the paper bank is
properly installed. For instructions on how to print a
configuration page, see "Printing the Test Page" in the "Operating
Instructions" that comes with the printer .
Copyright© 1999 - 2001
TAPP050E
TAPP061E
TAPP070E
G520-8610B
Advertisement
