Advertisement
HEIGHT ADJUSTMENT CONTROLLERS
3- Pre-Set Programmable
with Digital Display
OPERATING THE CONTROLLER
•
Press and hold either the
The digital controller will display the current height of the table.
•
To switch to a stored height in memory, use the three pre-set buttons.
A.
Press the numbered button that has the pre-set height stored into
memory once.
B.
The display will flash
time press the
stored height.
•
As a safety feature, the user must continuously hold down the button in order
for the table to move.
STORE HEIGHT INTO MEMORY
To set into memory the desired height for either seated or standing work, use the
three pre-set buttons.
•
Press either the
•
Press the
S button
•
The display will flash
of
pre-set buttons 1-3
showing
S1, S2
•
To pre-set additional heights repeat this sequence using the remaining 1-3 buttons.
ADJUSTING THE HEIGHT DISPLAYED
It may be necessary to adjust the height displayed. The controller will show 68 cm
or 22.5 inches at its lowest setting which is the default setting from the factory and
does not incorporate worksurface thickness or glide adjustments.
•
At the same time press the
display shows the correct height.
SWITCH DISPLAY FROM INCHES TO CENTIMETERS
Press and hold the
centimeters.
ERROR CODES
In the event of a fault, the digital display may show an error code. Refer to the
troubleshooting guide.
or
Up
go1, go2 or go3
or
Up
Down arrow
Up
or
Down arrow
once.
for three seconds. During this time press your choice
S
to set that particular height. The display will store by
or
for one second.
S3
S button
to change the displayed height from inches to
S button
to reach the desired height.
Down arrow
for three seconds. During this
and hold until the table reaches the
until the desired height is attained.
and the
Up
or
Down
arrow, until the
Advertisement
