Advertisement
HEIGHT ADJUSTMENT CONTROLLERS
Flush-Mount
Activation Buttons
OPERATING THE CONTROLLER
The flush-mount activation has two buttons for user control.
•
Press and hold either the
•
As a safety feature, the user must continuously hold down the button in order
for the table to move.
The buttons can be mounted with both the
Note:
visible on the top surface, or it can be wrapped around the worksurface edge for
an intuitive "push down", "pull up" action.
3 Pre-set
Programmable
OPERATING THE CONTROLLER
•
Press and hold either the
•
To switch to a stored height in memory press and hold the numbered button
that has the pre-set height stored into memory until it reaches the stored height.
•
As a safety feature, the user must continuously hold down the button in
order for the table to move.
STORE HEIGHT INTO MEMORY
To set into memory the desired height for either seated or standing work,
use the three pre-set buttons.
•
Press either the
•
Press the
S button
that
particular height.
•
To pre-set additional heights repeat this sequence using the remaining
1-3 buttons.
Raise
or
Up
or
Down arrow
Up
or
Down arrow
once and then your choice of
Lower buttons
to reach the desired height.
Raise
to reach the desired height.
until the desired height is attained.
pre-set buttons 1-3
and
Lower buttons
to set
Advertisement
