Sealey SEKC25 Instruction Manual

moDEl no's:
Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions and properly
maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND
CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY
CAUSE DAMAGE AND/OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS CABINET FOR
FUTURE REFERENCE.
1. SAFETY
WARNING! these cabinets are heavy and care should be exercised in transit and handling to ensure that no one is injured.

WARNING! the key cabinets are a 2 person job for installation.

for maximum security, these cabinets must be securely fixed to a wall.

Ensure that any wall used is sufficiently strong to carry the weight of the cabinet and its contents.

DO NOT install in areas where damp and condensation are present.

WARNING! the warnings, cautions and instructions referred to in this instruction manual cannot cover all possible conditions and situations

that may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be applied
by the operator.
2. INTRODUCTION
Heavy-duty construction with twin locking bolts. simple to operate electronic keypad accepts numbers of between three and eight digits, giving
millions of combinations. three lEDs show security, power and operating status.
also supplied with two keys for manual override should batteries fail. numbered, colour coded hook bars are adjustable to suit varying key sizes.
Includes anchor bolts. sEKc50 and sEKc100 are supplied with colour coded key rings for easy key location.
• CAUTION: If you, or an intruder, uses an incorrect group of numbers, the cabinet will not open and a yellow light will illuminate. Entering an
incorrect PIn 3 times will freeze the system for 20 seconds.
• Keep the cabinet key and any record of the combination separate from the cabinet and unidentified.
3. INSTALLATION
3.1. consideration should be given to the placing of the cabinet to ensure that it is placed in a discreet location and will not be easily found by
intruders.
3.2. Each cabinet is supplied with four anchor bolts suitable for fixing to brick and concrete.
3.3. fixing to hollow partition walls is not recommended. If fixed to wood it must be to a solid wooden structure.
3.4. open the door of the cabinet (see 4.1 / 4.3 for opening instructions) and with the help of a second person, position it where required and
mark the mounting positions through the pre-drilled holes in the back of the cabinet.
3.5. When mounting to a wall, ensure that the cabinet is adequately supported during the marking process.
3.6. Drill 10mm holes to a depth of 38mm (fig.1.1) and insert the anchor bolts with nuts and washers removed (fig.1.2).
3.7. Position the cabinet over the four protruding mounting studs and support it there whilst placing a washer, split washer and nut
onto each stud (fig.1.3).
3.8. continue to support the cabinet whilst tightening the fixings (fig.1.4).
fig.1
SEKC25
Original Language Version
InstructIon manual for:
ELECTRONIC KEY CABINETS
SEKC50 SEKC100
sEKc25, sEKc50, sEKc100 Issue: 2 - 31/10/11