Delivering Hot Water And Steam; Delivering Steam - DèLonghi PrimaDonnaS ECAM26455 Getting Started

DELIVERING HOT WATER and STEAM

Delivering hot water
1. Make sure the hot
water spout is
attached correctly.
Place a container
2.
under the spout
(as close as
possible to avoid
splashes).
button "Hot Water"
3. Press the
is displayed, together with a progress
bar which fills gradually as preparation
proceeds.
4. The machine delivers 10.5 oz./300 ml
of hot water, then delivery stops
automatically. To interrupt delivery of
hot water manually, press the
button again.
Important! Danger of burns.
Never leave the machine unsupervised while
delivering hot water or steam. The spout becomes
hot during delivery. Hold by the handle only.
Please note! If "Energy Saving" mode is enabled,
you may have to wait a few seconds before the
hot water or steam is delivered.

Delivering steam

1. Make sure the
hot water spout
is attached
correctly.
2. Fill a container
with the liquid
to be heated/
frothed and immerse the spout/
cappuccino maker in the liquid.
Press the button. After a few seconds,
3.
the steam to heat the liquid comes
out of the cappuccino maker.
4. When the required temperature/foam
is obtained, interrupt steam delivery by
pressing the button again.
(You should not discharge steam for
more than 3 minutes at a time).
Tips for using steam to froth milk
• When choosing the size of the
container, bear in mind that the liquid
doubles or triples in volume.
• For a richer denser froth, use
skimmed or partially skimmed milk
at refrigerator temperature (about
41°F/5°C).
• For a creamier froth, rotate the
container with slow movements in
an upward direction.
• To avoid milk with poor froth or large
bubbles, always clean the spout.