Advertisement
(Continued from the front page)
8.
Confirm there is a check in "Enable all ports". To change the
default pin out when a Cisco device is connected to the
selected port, click the "Enable Cisco RJ45 Pin-Out" checkbox.
To reconfigure the connections settings to match the device
connected to the selected port, make the needed changes in
the Communication Settings area of the screen. And then click.
These settings can be changed again later.
9.
Save is executed, and the screen below appears. Click [finish].
10. The First Time Configuration has completed, and Expert mode
screen appears.
＜Inquiry about our products＞
FUJITSU COMPONENT LIMITED Marketing Group
TEL: 81-3-5449-7006
E-mail: promothq@fcl.fujitsu.com
URL: http://www.fcl.fujitsu.com/en/
Step4 Access a Serial Device
Perform an operation on a connected serial device.
1.
Select "Access" from left menu in Expert mode, the content
area displays the name of this device and list of each port.
2.
Select "Serial Viewer" from the "Action" column
3.
Start up a Java applet, the following Serial Viewer window is
displayed. When the warning dialog appears, click "Run".
* When a popup block becomes effective in a browser (e.g.
Internet Explorer), Serial Viewer window is not displayed. You
have to configure a browser to admit popup window.
4.
The "Password:" prompt is displayed. Enter the current login
user password (in this case: admin).
5.
The following message appears, and serial device operations
are enabled.
6.
Click [Disconnect] in bottom of the Serial Viewer window or [x]
in top right of the Serial Viewer window to finish the operation.
Step5 Exit the Operation
Log out the OBWI after finishing the operation.
1.
Click [LOGOUT] in top right of the OBWI.
The basic operating procedure has completed.
NOTES
Installing Java Runtime Environment (JRE).
You have to install Java Runtime Environment (JRE) of Sun
Microsystems in a remote terminal to let this document Step4
display the serial viewer screen of mention. If not yet, download
Java software in the following web site and install it.
http://www.java.com/en/
Or, JRE is stored in CD-ROM, please
use it. In addition, by the setting of the browser, it is necessary
for JRE to become effective.
・A confirmation method of the JRE availability (IE 7)
Click [Tools] menu → [Internet Options] → [Advanced] tab.
Make sure that Java Sun [Use JRE 1.x.x._xx for <applet>
(requires restart)] is checked. (x is version No.)
For software setup or details on operations, refer to
the Installer/User Guide in the CD-ROM provided
with the device.
NC14013-0927RS-03
Advertisement
