Baby Lock Crown Jewel III BLCJ18-3 Instruction And Reference Manual page 35

Figure 44
Diagnostics
Motor
Needle
X Motion
Tension
Back
Figure 45
34
CAUTION: Users who have had cataract surgery
should not use the UV lighting unless they have had
UV A/B blocking replacement lenses implanted as part
of the surgery.
System Information
The serial number of the machine is displayed at the
top of the System Information screen. This number
matches the one found on the label at the back of the
machine under the rear handlebar.
Information contained in the boxes below the serial
number identifies the electronics board version num-
bers as well as the version numbers of the Baby Lock
Crown Jewel III and its handlebars. The Lifetime and
Project stitch counters count the number of stitches
the machine has performed. The Lifetime count is the
total number of stitches made since the machine was
built. The Project Counter can be reset to keep track of
the number of stitches made during a given project. To
reset this counter, press the gold "Reset" button just to
the right of the title box. The Lifetime counter cannot
be reset and should be used as an indicator to deter-
mine when general machine maintenance should be
performed by an authorized Baby Lock Retailer. (Fig-
ure 44)
Press the "Main" button to return to the "Regulated" or
"Manual" menu screen or the "Back" button to return
to the "More" menu screen.
Diagnostics Screen
Six different diagnostics tests can be performed on the
machine. These functions test the motion encoders,
the motor control functions, the key switches and the
Speed
internal position sensors (Figure 45).
Keys
Press the "Main" button to return to the "Regulated" or
"Manual" menu screen or the "Back" button to return
Y Motion
to the "More" menu screen.
Main