Inserting The Bobbin - Janome Horizon MC8900 QCP Special Edition Instruction Book

z
x
c
r
Correct
r
v
t
y
b
q
e
Wrong
r
u

Inserting the Bobbin

z Place the bobbin in the bobbin holder with the thread
running off counterclockwise as shown on the hook
cover plate.
CAUTION:
Always make sure to press the lockout key to lockout
the machine or turn the power switch off before
threading the machine.
x Hold the bobbin with your fingertip so it does not
rotate. Guide the thread into the front notch of the
bobbin holder. Pull the thread to the left to pass it
under the guide.
q Front notch
w Guide
w
c Draw the thread to the left to pass it into the guide
path marked "1".
Make sure that the thread comes out from the side
notch of the bobbin holder.
e Guide path 1
r Side notch
NOTE:
If the thread does not come out from the side notch,
rethread from step z.
v Continue to draw the thread along the guide path
marked "2" and pull the thread to the right through the
slit. The thread will be cut to a proper length and held
in place.
t Guide path 2
y Slit (Thread cutter)
b Set the left edge of the hook cover plate into opening.
Push down the hook cover plate to fit in place.
u Hook cover plate
NOTE:
Unless otherwise noted, you can start sewing without
drawing up the bobbin thread.
Refer to page 23 for how to draw up the bobbin
thread.
20