Dodge 2013 charger Owner's Manual page 167

Toggling Between Calls
If two calls are in progress (one active and one on hold),
touch the "Swap" soft-key on the Phone main screen.
Only one call can be placed on hold at a time.
You can also press the
active and held phone call.
Join Calls
When two calls are in progress (one active and one on
hold), touch the "Join Calls" soft-key on the Phone main
screen to combine all calls into a Conference Call.
Call Termination
To end a call in progress, momentarily press the
ton or the end soft-key. Only the active call(s) will be
terminated and if there is a call on hold, it will become
the new active call. If the active call is terminated by
the far end, a call on hold may not become active
automatically. This is cell phone-dependent.
button to toggle between the
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 165
Redial
• Press the "Redial" soft-key,
• or press the
and after the "Listening" prompt and
the following beep, say "Redial",
• After the "Listening" prompt and the following beep,
say "Redial",
• The Uconnect® Phone will call the last number that
was dialed from your mobile phone.
Call Continuation
Call continuation is the progression of a phone call on the
Uconnect® Phone after the vehicle ignition key has been
but-
switched to OFF.
NOTE: The call will remain within the vehicle audio
system until the phone becomes out of range for the
Bluetooth® connection. It is recommended to press the
"transfer" soft-key when leaving the vehicle.
3