ActionTec ScreenBeam SBWD100KIT Installation Manual

C
Pair the Receiver and Transmitter
1
Step
After your computer
finishes rebooting, click the
ScreenBeam icon on your
computer's desktop (circled in red).
2
Step
The main ScreenBeam
screen appears.Click Add a
Receiver.
3
Step
A new screen appears.
Select your Receiver, then
click Connect.
4
Step
A PIN appears on your
HDTV screen.
5
Step
Enter the PIN in the
ScreenBeam screen on your
computer within 60 seconds, then
click Next.
Your ScreenBeam Transmitter and
Receiver are now paired.
You should see your computer's
screen on your HDTV.
For Miracast or Intel WiDi Devices
• For Miracast devices: Consult with the user guide from your
device manufacturer.
• For WiDi devices: Make sure your WiDi software version is 3.5
or higher. To obtain the latest software, go to
http://downloadcenter.intel.com and search for "WiDi 3.5
software. "
Note: Actiontec recommends plugging in your laptop when
using ScreenBeam. If running your laptop on battery, make sure
its power settings are configured for "Maximum Performance. "
Please visit www.actiontec.com/screenbeam to register your
product and for more information, including:
• Videos • Diagrams • FAQs • Details • User Manual
©2012 Actiontec Electronics, Inc. Actiontec, Actiontec Installation Buddy, Creative
Solutions for the Digital Life, and the Actiontec logo are registered trademarks
or trademarks of Actiontec Electronics, Inc. Incorportated in the U.S. or other
countries. All other names are properties of their respective owners. Product photo
may differ from actual product. However, functionality remains as stated above.
Specifications are subject to change without notice.
Universal Wireless
Display Adapter Kit
ScreenBeam
Model # SBWD100KIT
Installation Guide
This Installation Guide will walk you through the easy
steps to set up your ScreenBeam Receiver and Transmitter.
During this process, we'll show you how to :
A
Install the Receiver
B
Install Software and
Transmitter
C
Pair the Receiver and
Transmitter
IMPORTANT NOTE: Federal Communication Commission (FCC) Radiation
Exposure Statement
This EUT is compliance with SAR for general population/uncontrolled exposure
limits in ANSI/IEEE C95.1-1999 and had been tested in accordance with the
measurement methods and procedures specified in OET Bulletin 65 Supplement
C. This equipment should be installed and operated with minimum distance
1.5 cm between the radiator and your body.
NEXT