Fastening The Adapter Cover; Connecting Power Supply - Dukane 8970 User Manual

Fastening the adapter cover

When using the USB wireless adapter, be
sure to connect the adapter to the further USB
TYPE A port from the LAN port and use the
supplied adapter cover.
1.
Loosen the screw (marked with triangle) on
the bottom left of the USB TYPE A ports.
2.
Insert the tab of the cover into the hole at the upper right of
the USB TYPE A ports in the direction of the arrow.
3.
Align the screw holes on the projector and the cover. Then
insert the screw removed from the projector into the hole and
tighten the screw.
WARNING ►Keep small parts away from children and
pets. Take care not to put in the mouth.
►Heat may build up in the USB wireless adapter, to avoid
possible burns disconnect the projector power cord for 10
minutes before touching the adapter.

Connecting power supply

1.
Put the connector of the power cord into the AC IN
(AC inlet) of the projector.
2.
Firmly plug the power cord's plug into the outlet. In a
couple of seconds after the power supply connection,
the POWER indicator will light up in steady orange.
Please remember that when the DIRECT POWER ON
function activated, the connection of the power supply
make the projector turn on.
WARNING ►Do not connect the projector to a power supply while no lens
unit is attached to it.
►Please use extra caution when connecting the power cord, as incorrect or
faulty connections may result in fi re and/or electrical shock.
• Do not touch the power cord with a wet hand.
• Only use the power cord that came with the projector. If it is damaged, consult
your dealer to get a new one. Never modify the power cord.
• Only plug the power cord into an outlet whose voltage is matched to the power
cord. The power outlet should be close to the projector and easily accessible.
Remove the power cord for complete separation.
• Do not distribute the power supply to multiple devices. Doing so may overload
the outlet and connectors, loosen the connection, or result in fi re, electric
shock or other accidents.
• Connect the ground terminal for the AC inlet of this unit to the ground terminal
of the building using an appropriate power cord (bundled).
NOTICE ►This product is also designed for IT power systems with a phase-
to-phase voltage of 220 to 240 V.
8
1
Power
cord
2
Tab
3
AC IN