TensCare TouchTENS XL-Y1 Instructions For Use Manual page 7

The unit has 60 levels of strength. If you hold down the button for
2 seconds, the strength will start scrolling.
You may feel nothing over the first few presses. Continue pressing
until the sensation is strong but comfortable. Further increases
during use may be necessary if your body becomes used to the
sensation.
To lower the strength, press and release the lower part of the
blue buttons marked ▼.
PROGRAMME CONTROL
The YELLOW BUTTON, marked #, is
the Programme control. The Touch TENS
has eight different, specially developed
programmes lettered A-H.
When the unit is first switched on it automatically enters
PROGRAMME A.
Each time you press and release the YELLOW BUTTON, the
programme changes and the letter is shown on the LCD.
Each time you change the programme, the strength level reverts
back to zero. This is a safety feature to alleviate any sudden feeling
of a surge, as each Programme gives a different sensation.
TIMER
The GREEN BUTTON, marked with a
clock symbol, can be used to set the
session duration.
When you switch the
set at continuous, (displayed as CO) which means that the unit
will continue functioning until you switch it off.
unit on, it is automatically
9
You can set session times of 20,40, or 60 minutes by pressing
the green button repeatedly.
The LCD shows the session duration next to the clock symbol.
The unit automatically counts down the minutes set and switches
off when this reaches zero.
A LOW BATTERY display, with a symbol of empty batteries, will
show when you need to change the batteries. The unit will shut
down about 2 minutes after this.
KEYPAD LOCK
If you do not press any keys for 30 seconds, the
keypad will lock so that only the keys marked ▼ will
work. This is to avoid accidental changes in setting.
To unlock, press either ▼ key.
OPEN CIRCUIT CUTOUT
If the Touch TENS is not correctly connected to your body, the
strength will automatically reset to zero. This is to prevent sudden
changes if a broken connection is re-made.
MEMORY
The XL-Y1 has a Memory with three functions:
1) Programme Retention. When you switch the unit On, it will
automatically start in the Programme which was being used
when it was switched Off.
2) Frequency of Use. Press Programme and Left blue ▲ together
and hold down for 3 seconds. The display will show T (for no. of
Times) and a number from 1 to 9999, indicating the number of
times the unit has been used.
Press the same buttons again to return to normal controls.
10