Table of Contents
Advertisement
INSTALLER AND OWNER GUIDE
3. Drill an appropriate size hole in the
marked position.
4. Insert a wall plug into the drilled hole.
5. Screw the eyescrew into the wall plug.
6. Position the heater in front of the
fireplace opening.
7. At the top of the heater there are four
small holes, two each side of the heater
(See figure 7- Item 1). From the front of the
heater, thread about 50mm ( 2 inches) of the
steel wire into the inside small hole on the
left side of the heater (See figure 7 - item
2).
8. Thread the other end of the wire through
the remaining small hole on the left hand
side of the heater. Continue to push the
wire through this hole until there is only
a small loop of wire at the front of the
heater (See figure 7 - item 3).
9. At the back of the heater there will be
a long piece and a short piece of wire
coming through the two holes. Hold the
short piece and give the long piece a
gentle tug. This will secure the steel
wire. Take the long piece and thread this
through the eyescrew in the back of the
fireplace opening (See figure 7 - item 4).
10. From the back of the heater thread
the long piece of steel wire through the
outer small hole on the right hand side
of the heater (See figure 7 - item 5).
11. Locate the heater in the fireplace
opening, then from the front of the
heater, gently pull the steel wire on the
right hand side to gather up the excess
until the heater is secure. Thread the
wire through the remaining small hole to
lock the wire and heater in place (See
figure 7 - item 6).
Figure 6. Eyescrew position.
Figure 7. Steel wire fixing (Detail at top of
heater may differ from that shown)
Page 9
Advertisement
Table of Contents
