Baxi 807 Installer And Owner Manual page 4

INSTALLER AND OWNER GUIDE
Use gloves to provide additional grip.
!
Always use assistance if required.
!
Always
Always install the heater in accordance with this guide. If in doubt obtain
!
expert advice.
Always make sure the electrical socket is accessible and located adjacent to, but
!
not above the heater.
Always disconnect the heater from the electrical supply before carrying out
!
cleaning, maintenance or replacing the light bulb.
Always make sure the heater is firmly secured to prevent it from being tipped over.
!
Always use a fireguard when young children and infirm persons can come into
!
contact with the heater.
Always use genuine Baxi Fires Division spares.
!
Never
Never leave children unsupervised in a room where the heater is ON and
!
unguarded.
Never obstruct or cover the fan outlet or force items into heater openings.
!
Never install or use the heater anywhere where water is in use, i.e.
!
Bathrooms, Kitchens, Shower Rooms, Swimming Pools etc.
Never use aerosols or steam cleaners on or around the heater.
!
Never route the mains supply cable under carpet etc.
!
Never install the heater close to curtains or combustible materials.
!
Never use the heater to dry clothes etc.
!
Never sit or stand on the heater.
!
The installation of this heater requires a reasonable level of DIY skills.
Please read this guide thoroughly before commencing installation and if in doubt,
seek help from a competent person
Do I need any tools?
1. You will need two screwdrivers: -
1 off Pozidrive / Phillips / cross head screwdriver. This should have a number 2 size
end. If you are unsure about the size of the end simply make sure that the end fits into
the screws supplied with the heater. If the end is too small then the end will spin and
damage the screw.
1 off Flat end screwdriver. The end should fit into the slot head screws supplied with
FITTING THE HEATER
Page 4