Removing The Fascia - Baxi 807 Installer And Owner Manual

Electric heater fitted with one of the following fascia adage, alisa, anthem, dream, eternal, manor, ocean, ultimate or victorian.

Hide thumbs

Table Of Contents

Table of Contents

INSTALLER AND OWNER GUIDE

cutout on the right side of the heater. If required, the

cable guide can be removed and put in the

rectangular slot in the centre or left hand side of the

heater. For removal and fitting please see the

following sections.

Removing the cable guide

1. Before removing the cable guide please note that

the wider part of the cable guide is on the outer edge

of the base (See figure 1- Item 1).

2. To remove the cable guide push and lift the tab on

the bottom of the cable guide. The bottom of the

cable guide will open (See figure 1- Item 2).

3. Lift the electric cable clear of the cable guide.

4. Hold the bottom of the cable guide close to the

heater then gently pull the cable guide away from

the rectangular slot (See figure 1- Item 3).

Fitting the cable guide.

When fitting the cable guide please remember that

the wider part of the cable guide has to be fitted

against the outer edge of the base (See figure 1- Item

1).

1. Gently pinch the sides of the cable guide (See

figure 1 - Item 4) and push the cable guide into the

required rectangular slot.

2. Place the electrical cable into the guide and close

the top of the cable guide.

If the mains cable is damaged, to avoid a hazard it

must be replaced by a Baxi Fires Division authorised

service agent, or similarly qualified person (See the

last page of this guide for useful telephone

numbers).

All external wiring between the heater and the

electrical supply shall comply with current IEE

regulations.