Assembly - Husqvarna TS 355 B Operator's Manual

Diamond Blade Installation
When installing the Retaining Screw (E4), do not
"cross-thread" or over tighten the screw.
• Identify Motor Shaft, Retaining Screw (E4) and Outer
Flange (E2).
• Hold Shaft Wrench (H6) stationary. Rotate Blade
Wrench (H5) counter-clockwise. Remove Retaining
Screw and Outer Flange.
• Seat Blade (H8) on Inner Flange (F3). Verify rotation
direction.
• Hold Shaft Wrench (H6) stationary. Rotate Blade
Wrench (H5) clockwise. Install Retaining Screw (E4)
and Outer Flange (E2). Tighten.
13

ASSEMBLY

NOTICE
Motor
Shaft
E2
H6
H5
F3
H6
H5
E4
H8