Front Callouts - Samson MXS3000 Owner's Manual

Mxs series 5400, 4600 watt stereo power amplifier
Hide thumbs Also See for MXS3000:
Table of Contents

Advertisement

Front Callouts

1
1.
Power Switch - Use this switch to power the MXS amplifier on or off
2.
Channel Level Controls - Two detent controls to precisely adjust and the match the
output level of each channel
3.
MODE Indicators - The corresponding indicator lights based off of the setting of the
rear panel MODE switch (Stereo, Bridge, Parallel).
4.
FILTER Indicators - These LED indicators light depending on the setting of the rear
panel FILTER switch (Full, 28Hz, 120Hz).
5.
Audio Indicators - The front panel LED indicators monitor the power output level for
the corresponding channel:
PEAK:
The PEAK indicator lights whenever the channel is outputting signal
at full strength. For the best signal-to-noise ratio, the right (PEAK)
segment should light occasionally during peak levels; if it lights
frequently, you may be overloading the amplifier and a distorted
("clipped") signal is probably being output.
-10:
Lights whenever the output level reaches -10dB below the distortion or
clipping
SIGNAL: These LED indicators continuously monitor the input level for the
corresponding channel. The SIGNAL LED lights whenever signal is
present.
MXS Series Power Amplifiers
2
3
4
5
2
5
9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mxs3500

Table of Contents