Preparation For Use; Guide Bar/Saw Chain Installation/Removal - Echo CS-303T Instruction Manual

Bolt (A)
Dimple (D)
Kick Guard
Recess (E)
Nut (F)
Clutch cover
CS-303T

PREPARATION FOR USE

®
Rear hole (B)
Front hole (C)
Guide bar
Unlock chain brake
Brake lever
(Front hand guard)
Two nuts
Saw chain is sharp! Always wear gloves
when handling assembly, otherwise serious
personal injury may result.
KICK GUARD
INSTRUCTIONS
Tools Needed: Two 11 mm (7/16 in.) Wrenches.
For saws with Kick Guard
Symmetrical Low-Kick type (Double Guard)
guide bars.
1. Install bolt (A) in rear hole (B) of Kick Guard
and through front hole (C) in guide bar.
2. IMPORTANT: Dimple (D) in Kick Guard
engage recess (E) in guide bar.
3. Tighten nut (F) and bolt (A) using 11 mm (7/16
in.) wrenches until snug. Make certain Kick
®
Guard is flush against guide bar.
4. Tighten nut (F) 1/8 additional turn.
5. Check to make certain Kick Guard
guide bar.
GUIDE BAR AND SAW CHAIN
INSTALLATION/REMOVAL
NOTICE
• Move the chain brake lever (Front hand guard)
fully rearward to remove or install the clutch
cover to chain saw.
1. Remove spark plug lead.
2. Remove the clutch cover nuts and remove clutch
cover.
3. Remove bar and saw chain if necessary. See
"Maintenance and Care" section for guide bar/
saw chain maintenance procedures.
10
WARNING
®
TO BAR
®
P/N 2893201 and
®
®
is tight on
®
must