Vaz -21213 Repair Manual page 18

Fig.2-22. Camshaft bearing housing nuts tightening sequence
Adjust the clearance between the camshaft lobes and valve
levers.
Refit the camshaft cover (Fig.2-23) complete with the gasket
and oil seal to the cylinder block, do not tighten the retaining bolts
and nuts fully. Using tool 41.7853.4010 centralize the cover
against the crankshaft end, then tighten the retaining nuts and
bolts to the torques specified.
Fit the alternator and oil pump pulley, then secure it with the
nut.
Fit the oil filter complete with the gasket, manually screw it to
the union on the cylinder block. Refit the crankcase vent oil sep-
arator, breather cover and secure the oil separator drain pipe with
the clip.
Fit oil pump 1(Fig.2-24), then fit the oil sump with the gasket.
Fit the coolant pump, alternator bracket and alternator. Fit the
belt around the pulleys and adjust the belt tension.
Fit the heater matrix supply pipe and cooling water jacket out-
let pipe to the cylinder block. Secure the heater matrix drain pipe
to the coolant pump and outlet pipe.
Fit the instrumentation sensors.
Fit the oil pump / distributor gear, followed by the ignition dis-
tributor. Insert the spark plugs, place spanner 67.7812.9515 on
the spark plugs and tighten the spark plugs with a torque wrench
to the torques specified.
Fit the fuel pump as outlined in section «Fuel system».
Fit the carburettor and reconnect the hoses. Cover the car-
burettor with a provisional cap.
WARNING. Never secure the carburettor (or tighten its
retaining nuts) when it is warm.
18
Fig.2-23. Timing cover
Projections (arrowed) for cover centering against crankshaft pulley hub
Fit the valve cover complete with the gasket and fuel piping
bracket.
Fit the air cleaner, to do this secure the hoses to the air clean-
er housing, fit the filter housing complete with the gasket to the
carburettor, then fit the mounting plate and secure the housing
with nuts. Locate the filter element and secure the air cleaner
cover.
Reconnect the HT leads to the distributor and spark plugs.
Fill the engine with motor oil through the oil filler in the valve
cover.
Fig.2-24. Refitting the oil pump:
1 - oil pump; 2 - drain pipe lock; 3 - oil separator drain pipe