Table of Contents
Advertisement
MOUNTING THE LIGHT UNIT ON A HELMET
(3/3)
6
Position alignment mark
7
Battery unit
Slide
Connect the plug so that the directions of the arrow and the
mark match.
To remove the plug, hold the ring, and then pull out the plug.
Extension cable
Unlock
Lock
Knob
Control unit
Plug
Ring
Set the knob of the control unit to the "Unlock" position, align
the battery unit with the position alignment mark, and then slide
the battery unit into place.
CAUTION!:
After you connect the battery unit, be sure to
set the knob back to the "Lock" position to
lock the battery unit in place.
To remove the battery unit, set the knob to the "Unlock" posi-
tion, and then pull out the battery unit.
8
Insulation
sheet
(WSW-001)
Check that the light turns on when you press the remote control
switch near the control unit.
CAUTION!: Do not look directly at the light when it is on.
Rubber band
9
Advertisement
Table of Contents
