Operation Of Saw; Chain Tension - Reliable Equipment LR 88.5 Operator's Manual

PRE-OPERATION OF SAW
WARNING! DO NOT connect hoses or fittings to this chainsaw before completing all
the following instructions.
Before attempting to run or use the saw, check all connections, including hoses, couplings,
chain tension, cleanliness of the fiberglass extension, trigger latch, freely moving trigger,
and the condition of the rubber behind the trigger. Wear all safety items required and
make sure that the working area is clear of obstructions. Set saw to Open or Closed
Center, according to which system the power supply pump provides. It is important to
know which type of power system is supplying the saw so that the chainsaw can be
properly set. All these items are crucial to the safe operating procedure of the chainsaw.
Setting Spool Selector for Open Center/Closed Center System
FIGURE 1
Make sure hoses are disconnected from the chainsaw and inspect the following items:
Inspect the saw chain. The chain tension should be set per Fig. 3. If the tension is too
tight, the saw guide will wear excessively. If the tension is too loose, the chain could
jump the track. Follow the settings as described in Fig. 3.
Set the automatic oiler as described in Fig. 2. If set properly, a fine mist should show at
the tip of the chain. Too much fluid will drain the reservoir of oil. Follow the instructions on
page 11. Check the fluid level regularly for fluid loss.
Inspect the chain for damage. The saw will not function properly with a worn or damaged
chain. Look for bending, wear, or any damage to the chain assembly.
Damaged chain assemblies could cause pinching or kickback, resulting in serious injury
to the operator.
Set the Hand Stop approximately 36" from the handle (shown as item 4 on page 15.)
This should be a comfortable position for the average person.
New saw chains require a break-in period. The chain tension will need to
be adjusted frequently as described on page 12.
CAUTION
9