Sound Devices MM-1 User Manual And Technical Manual page 5

Input:
(Mic)
Input:
(Monitor)
Output:
(Line)
Headphone Output
Impedance:
Frequency Response:
(Monitor In)
Frequency Response:
(Headphone Out)
Input Clipping Level:
(Monitor In)
High-Pass Filter:
Phantom Power:
T-Power:
Limiter:
Internal Voltage
Rails:
Power:
Polarity:
Weight:
(unit only)
Dimensions:
(unit only)
Included Accessories:
Transformer-balanced, 2k ohm input impedance
Electronically-balanced, 22k ohm input impedance
Transformer-balanced, 130 ohm output impedance
Unbalanced, 200 ohms
10 Hz – 50 kHz, ±0.5 dB, gain at 50 %
10 Hz – 50 kHz, ±0.5 dB, gain at 50 %
greater than +30 dBu
80 Hz or 160 Hz (switch selectable), 6 dB per octave
12 V or 48 V (switch selectable),
will supply 10 mA per DIN 45 596 specification
12 V via 180 ohm resistors, will supply 10 mA
Limits to +17 dBu output level, 10:1 limiting ratio
5 ms attack time, 100 ms release time
Amber/Red LED indicates limiting/clipping
±15 V, regulated
Internal: 2 x AA batteries
External: 5 – 17 VDC via threaded coaxial jack, (5.5 mm
outer diameter, 2.1 mm inner diameter), pin positive, sleeve
negative.
Voltages above 17 VDC cause no damage to unit but will
open an internal poly fuse. Poly fuse will reset when voltage
is removed.
All inputs to all outputs are non-inverting.
XLR – pin 2 = hot, pin 3 = cold, pin 1 is ground.
TRS – Tip = hot, ring = cold, sleeve = ground
0.64 kg
1.42 lbs.
49 mm x 95 mm x 166 mm (h x w x d)
(1.95" x 3.75" x 6.55")
- Mating DC power connector
- 4 rubber feet
www.sounddevices.com
page 5