Mounting Controller To Wall - Hunter 600i Owner's Manual And User's Manual

MOUNTING CONTROLLER TO WALL...................................................................................

NOTE: The SRC is not water or weather resistant.
The controller must me installed indoors or in a
protected area. If outdoor installation is desired,
the MPC (an optional outdoor mounting enclosure)
is available.
1. Select a location as close as possible to a standard electrical outlet,
one that is not controlled by a light switch. The location should be
protected from moisture and direct sunlight.
2. Remove the mounting bracket (A) from the back of the controller
housing by pulling the bracket down and slightly away from
the unit.
3. Place the mounting bracket slightly below eye level. Using the hole
at the top and the slide cutout at the bottom, secure the bracket with
the 1" (25mm) screws (B) provided. Note: Install screw anchors if
attaching mounting bracket to drywall or masonry.
4. Align slotted openings on back of controller housing (C) with rails
on the mounting bracket (D). Gently slide the controller down into
position on the bracket.
5. Secure controller in place by installing a screw through the lower
central mounting hole.
Do not plug transformer into power source until
the controller is mounted and all valves have
been connected.
4
A
B
D
C