Rinnai RHFE-1004FTR How To Use Manual page 24

SLEEVE AND MANIFOLD INSTALLATION
5. Check rubber seal is in place on terminal.
For weather board walls, add spare rubber
seal provided to compensate for weather
board angle.
6. Installation of Terminal.
From outside, insert terminal into sleeve
with the "A" mark at the top.
Left hand side fixing tie is marked "LEFT"
(from inside) .
7. Attaching Ties.
Pull hard on left and right hand side ties.
clip ties over lugs inside sleeve.
You should be able to pull the ties 2 or 3
slots past the starting point.
Cut the ties. leaving about 20mm past the
lugs. Bend ties so they are parallel with
the wall.
8. Insert Inner Connection Assembly Push
assembly into terminal tube, make sure
"TOP" mark is uppermost.
Fix with 3 screws provided.
9. Manifold can still be turned after attaching.
("A" Flue supplied as standard)
METHOD FOR STANDARD WALLS
Terminal seal
(Add "weather board"
seal here)
Label
Fixing tie
Cut (leave 20mm free)
Pull hard
Fixing tie
Screw
lnner
Connections
Outlet
Inlet
– 23 –
Terminal
Terminal
Lug
Sleeve
Top Mark
Rubber cap
"TOP" mark "A"