Other Operating Information - Rinnai RHFE-1004FTR How To Use Manual

OTHER OPERATING INFORMATION

■ HUMIDIFIER TRAY
Your 1004FTR is fitted with an enamelled tray
behind the air outlet so that you can humidify the
air. To fill the tray, open the door as shown in the
diagram and pour water into the tray using the
spout built into the door.
The air will be humidified as it passes over the
water in the tray. DO NOT FILL THE TRAY
WHILST THE UNIT IS IN OPERATION. CLOSE
THE DOOR AFTER FILLING. The 1004FTR is a
very high efficiency appliance. During operation
a small amount of water is produced in the flue
tubes. This drains into the enamel tray. It is
quite normal for a small quantity of water to
remain in the bottom of the tray. If you are using
the humidifier, it will need filling about once a day
during the peak heating season.
■ FAN FILTERS
To protect the fan from dust and lint, the
1004FTR is fitted with 2 fan filters. They are
located at the top, rear of the unit. To clean, pull
the filters out of the unit and remove dust with a
soft brush or a vacuum cleaner. Re-fit filters
after cleaning. Your 1004FTR has a filter clean
warning indicator that will illuminate when
required, however, weekly cleaning is
recommended during the peak heating season.
■ OUTSIDE FLUE
On cold days steam may be discharged from the flue outlet. This is normal with a high
efficiency appliance and does not indicate any fault.
The heater and its flue must be installed correctly by an authorised person, and the
installation must conform to all local regulations.
The installation also must comply with the instructions supplied by Rinnai.
This heater must be serviced, installed and removed by an authorised person.
No parts or functions should be modified or permanently removed from the heater or its flue.
Humidifier Tray
Max. Fill Line
– 16 –
Access Door
Pull
Filler Spout
Do not force door open too far.
Close door during operation.
Fan Filters
Filter clean
warning
indicator
o
F ilt r e N