Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Current Audio AMP-1270
Summary of Contents for Current Audio AMP-1270
- Page 1 AMP-1270 AMP-870 Instruction Manual...
-
Page 2: Safety Instructions
This product conforms to all EU Directive requirements as applicable by law. The complete Declaration of Conformity can be found at compliance.currentaudio.com www.currentaudio.com 1890 Cordell Court, Suite 105., El Cajon, CA 92020 • 866-927-7181 ©2014 Current Audio - All Rights Reserved. Rev. 01, 04/14... -
Page 3: Supplied Accessories
Thank you for purchasing a Current Audio Multi-Channel Amplifier. Please read this manual thoroughly before making any connections or applying AC power. This manual applies to both the AMP-1270 and the AMP-870. The AMP-870 has fewer channels (eight) compared to the AMP-1270 with twelve channels. - Page 4 LED must be red. The tip of the plug is (+). (3)It can be triggered ON by Music Auto Sense. In this mode unit will turn OFF after a 10 minuet delay of no signal. www.currentaudio.com 1890 Cordell Court, Suite 105., El Cajon, CA 92020 • 866-927-7181 ©2014 Current Audio - All Rights Reserved. Rev. 01, 04/14...
-
Page 5: 12Vdc Trigger In/Out
Insert same signal to both Line In Allows user to switch fro 115VAC inputs for stereo. Requires two (2) to 220VAC. Zones. www.currentaudio.com 1890 Cordell Court, Suite 105., El Cajon, CA 92020 • 866-927-7181 ©2014 Current Audio - All Rights Reserved. Rev. 01, 04/14... -
Page 6: Installation
Getting Started Amplifier Placement Current Audio amplifiers require plenty of free air space for safe and proper operation. The following diagram indicates the minimum amount of free air space to provide the proper ventilation and heat exchange. Anything less than this will shorten the life of the equipment and may cause the amp to shut down. - Page 7 1890 Cordell Court, Suite 105., El Cajon, CA 92020 • 866-927-7181 1890 Cordell Court, Suite 105., El Cajon, CA 92020 • 866-927-7181 ©2014 Current Audio - All Rights Reserved. ©2014 Current Audio - All Rights Reserved. Rev. 01, 04/14...
-
Page 8: Setup Selections
2nd zone. (-) Speaker Lead to R+ Proper Wiring for (+) Speaker Lead to L+ Bridge Mode www.currentaudio.com 1890 Cordell Court, Suite 105., El Cajon, CA 92020 • 866-927-7181 ©2014 Current Audio - All Rights Reserved. Rev. 01, 04/14... - Page 9 The front Power Switch must be in the Standby Mode to operate. The LED on the Switch will illuminate red when in Standby mode and turn Blue when triggered. This indicates the amplifier is active. www.currentaudio.com 1890 Cordell Court, Suite 105., El Cajon, CA 92020 • 866-927-7181 ©2014 Current Audio - All Rights Reserved. Rev. 01, 04/14...
-
Page 10: Bridged Output
Zone 3 Zone 4 Zone 5 Zone 6 Bridged Output Normal output for stereo for Stereo (Note Inputs) www.currentaudio.com 1890 Cordell Court, Suite 105., El Cajon, CA 92020 • 866-927-7181 ©2014 Current Audio - All Rights Reserved. Rev. 01, 04/14... - Page 11 Zone 3 Zone 4 Zone 5 Zone 6 Bridged Output Normal Output for Stereo for Stereo (Note Inputs) www.currentaudio.com 1890 Cordell Court, Suite 105., El Cajon, CA 92020 • 866-927-7181 ©2014 Current Audio - All Rights Reserved. Rev. 01, 04/14...
-
Page 12: Troubleshooting
Power Switch on front panel Make sure the Switch is in standby mode Working indicated by a RED light. BLUE when triggered. www.currentaudio.com 1890 Cordell Court, Suite 105., El Cajon, CA 92020 • 866-927-7181 ©2014 Current Audio - All Rights Reserved. Rev. 01, 04/14... - Page 13 Current Audio, LLC Authorized Dealer or Distributor. In the event of defective materials and or workmanship, Current Audio, LLC will repair or replace, at its option, the defective product at no charge to the purchaser. In order to make claim under this Warranty and to obtain performance of any obligation under warranty, please contact Current Audio or your Au- thorized Distributor.
- Page 16 1890 Cordell Court, Suite 105., El Cajon, CA 92020 • 866-927-7181 Rev. 01, 04/14 ©2014 Current Audio - All Rights Reserved.
Need help?
Do you have a question about the AMP-1270 and is the answer not in the manual?
Questions and answers