Subscribe to Our Youtube Channel
Related Manuals for Current Audio AMP-2150
Summary of Contents for Current Audio AMP-2150
- Page 1 Two Channel 150 Watt Digital Class D Amplifier Instruction Manual www.currentaudio.com ©2013 Current Audio LLC 1890 Cordell Court, Suite 105 El Cajon, CA 92020 Sales 866-927-7181 AMP2150 RPA 11152013...
-
Page 2: Safety Instructions
This product conforms to all EU Directive requirements as applicable by law. The complete Declaration of Conformity can be found at compliance.currentaudio.com www.currentaudio.com ©2013 Current Audio LLC 1890 Cordell Court, Suite 105 El Cajon, CA 92020 Sales 866-927-7181 AMP1270 RPA 11152013... -
Page 3: Specifications
Thank you for purchasing the Current Audio Two Channel Amplifier. Please read this manual thoroughly before making any connections or applying AC power. This manual applies to the AMP-2150. See our multichannel four and six zone amplifiers. AMP-870 with eight channels and AMP-1270 with twelve channels. - Page 4 Welcome to D-Force by Current Audio D-Force describes the latest digital technology in amplifiers by Current Audio. The D-Force amplifiers generate the equivalent analog output for speakers by using a modulated audio signal rather than the traditional digital to analog conversion.
-
Page 5: Rear Panel Elements
Replace MASTER POWER only with correct fuse. Shuts OFF all power to the amplifier. Use for service. www.currentaudio.com ©2011 Current Audio LLC 1890 Cordell Court, Suite 105 El Cajon, CA 92020 Sales 866-927-7181 AMP1270 RPA 11152013... -
Page 6: Getting Started
Getting Started Amplifier Placement Current Audio D-Force amplifiers require adequate free air space for safe and proper operation. The following diagram indicates the minimum amount of free air space to provide the proper ventilation and heat exchange. Anything less than this will shorten the life of the equipment and may cause the amp to shut down. -
Page 7: Speaker Outputs
(+) Red of the speaker and the Black (-) of the amp to the Black (-) of the speaker. If they are connected out of phase, the mid and low frequencies will cancel and the speakers will not perform as intended. www.currentaudio.com ©2013 Current Audio LLC 1890 Cordell Court, Suite 105 El Cajon, CA 92020 Sales 866-927-7181 AMP2150 RPA 11152013... -
Page 8: Loop Output
RED binding post. Even though it may appear wrong this is correct. Check your work. If you require stereo you will require another AMP-2150. Designate one of the amps as LEFT and the other amp as the RIGHT channel. - Page 9 3.5mm phone plug. The front Power Switch must be in the Standby Mode to operate. The LED on the Switch will illuminate red when in Standby mode and turn Blue when triggered. This indicates the amplifier is active. www.currentaudio.com ©2013 Current Audio LLC 1890 Cordell Court, Suite 105 El Cajon, CA 92020 Sales 866-927-7181 AMP1270 RPA 11152013...
- Page 10 Blu-Ray Multi-room/tape Output Output Line In Input LEFT RIGHT OC8B Bridged Output Mono RIGHT RIGHT LEFT LEFT Normal Output for Stereo www.currentaudio.com ©2013 Current Audio LLC 1890 Cordell Court, Suite 105 El Cajon, CA 92020 Sales 866-927-7181 AMP1270 RPA 11152013...
-
Page 11: Troubleshooting
Make sure the Switch is in standby mode Power Switch on front panel indicated by a RED light. BLUE when triggered. Not Working www.currentaudio.com ©2013 Current Audio LLC 1890 Cordell Court, Suite 105 El Cajon, CA 92020 Sales 866-927-7181 AMP2150 RPA 11152013... -
Page 12: Warranty
Limited 1 Year Warranty Current Audio, LLC amplifiers are warranted to be free from defects in materials and or workmanship to the original retail purchaser for a period of 1 year, provided the equipment was purchased and installed from a Current Audio, LLC Authorized Dealer or Distributor.
Need help?
Do you have a question about the AMP-2150 and is the answer not in the manual?
Questions and answers