Advertisement
ARMING THE ALARM SYSTEM WHILST REMAINING ON THE PREMISES
1.
Key in your 4 digit pin number.
2.
Press Part set key
3.
The indicators illuminate to show which zones are being armed.
To add or remove a zone, press the appropriate number key.
A flashing indicator means that a door has been left open.
4.
Vacate the protected area via your designated exit route.
5.
Wait for the exit timer bleep to stop. The system is then armed.
If the bleep does not stop, return to the panel to identify where the fault is.
If the detectors are not clear to set, i.e.. A door is still open, the affected zone
indicator will flash and will prevent arming until either the
been
closed , or that zone is omitted.
When armed all zone and fault indicators will be extinguished.
DISARMING THE ALARM SYSTEM
1.
Enter the protected area by the designated entry route.
2.
Go straight to the panel.
3.
Key in your 4 digit pin number.
If you do not disarm the system before the entry time has expired, the alarm
will operate.
PROTECTION WHILST YOU ARE AT HOME
If you have a portable panic button a full alarm will be initiated by pressing the Panic
button for one second. Refer to the rear page to see if your panic button has been
set for silent or audible operation.
The Part Set facility allows part of the system to be armed whilst you are at home.
For example detectors downstairs can be armed whilst you are in bed. Or a part
of the building can be armed whilst you are working in another part of the premises.
CHANGING YOUR PIN NUMBER.
You can change your 4 digit PIN number at any time by the following sequence.
1.
Enter your 4 digit pin number.
2.
Press key 7.
The full set indicator on the panel will flash.
door has
3
3.
Key in your new 4 digit pin number twice.
The flashing indicators will now stop.
If you make a mistake when keying in a number, press the Full Set key to exit and start again.
The number will not change until you have keyed in the same 4 digit PIN number twice.
If no key is pressed for 20 seconds the program mode is aborted and the panel will revert
to the original pin number.
ALARM MEMORY
Following an alarm the event leading to the alarm is stored in memory. At any time whilst
unset, the alarm display can be recalled in order to verify what occurred.
Press the full set button
- The detector or fault which initiated the last alarm will be
displayed.
Pressing the Part Set button - Recalls the most recent event.
Pressing 0 returns the display to normal.
CHIME OPTION
If you require a detector to trigger a chime. i.e. To give an audible indication when someone
enters via the front door, you may set the sensor on that door to operate a chime.
To set or remove chime:
1.
Key in your pin number
2.
Press the 8 key.
The Full set indicator will flash.
3.
Press the number keys to select which zones will chime.
The zones with their indicators illuminated will chime.
The zones not illuminated will not chime.
4.
Press the Full Set key when you have set the desired chime zone
4
Advertisement
