Maytag MED5100DC Installation Instructions Manual page 20

6.
Rotate and reassemble outer window
assembly to trim ring
Notches
With the edge with 2 notches at the top, align the notches on
the outer window assembly with the tabs on the trim ring and
lower into place as shown in figure A.
Rotate the outer window assembly counterclockwise to lock
tabs into place (figure B). Using a Phillips screwdriver, secure
with 2 screws removed earlier.
IMPORTANT: Do not overtighten.
20
7.
Remove hinge and latch
Bottom
of door
Fig. A
Using a T25
®
securing the latch plate and latch backing plate and the
5 screws holding the hinge assembly in place.
8.
Reinstall hinge and latch on
opposite sides
Fig. B
Using a T25
®
backing plate, and hinge assembly on the opposite sides
from which they were removed.
Latch
screwdriver, remove the 3 TORX
screwdriver, reinstall the latch plate, latch
Hinge
screws
®