Preparing For Use; Suggested Coffee Measurement Chart; Water Filtration System - Mr. Coffee SCTX Series User Manual

Table of Contents

Advertisement

Available languages

Available languages

2. Press and hold the HOUR and MINUTE buttons until you
reach the current time. The AM or PM indicator will light
at the bottom of the display (Figure 1).
The clock is now set!
NOTE: Pressing any button before
setting the clock will cause the clock to
start keeping time from 12:00 a.m. You
must set the clock if you want to use the
Delay Brew feature.
To Set the Delay Brew Time:
While the display is in the clock mode,
simply press the SET DELAY button
(Figure 2) and, set the brew time by
pressing the HOUR and MINUTE buttons
(Figure 3). The AM or PM indicator will
light at the bottom of the clock display.
Within a few seconds the display will change to the
current time. The Delay Brew Time is now set!
NOTE: To activate the DELAY BREW cycle, see the
Brewing Coffee Later section.
To check the programmed time, push the SET DELAY
button. The display will show the time you have
programmed the coffee to brew. If you press the SET
DELAY button again or wait a few seconds, the display
will switch back.
IMPORTANT: EMPTY AND CLEAN CARAFE AND PLACE IT
UNDER THE BREW BASKET BEFORE BREWING.

PREPARING FOR USE

Selecting and Measuring Ground Coffee
For best results, use a level tablespoon for ground
coffee measurement. Make sure you use medium grind
10
coffee for a perfect brew.
A. Suggested Coffee Measurement Chart
To Brew Ground Coffee
12 Cups
Figure 1
8 Cups
6 Cups
4 Cups
B. Water Filtration System
Figure 2
Congratulations! You are the owner
of a MR. COFFEE
system. Using the Mr. Coffee
based water filter in the Mr. Coffee
Figure 3
coffeemaker during the brewing
process helps remove up to 97%
of the chlorine from the water and
improves the taste of your coffee.
To use the water filtration system in your MR.
COFFEE
steps:
1. Align the red indicator on the frame to the
letter that corresponds with the month that
you are using the disk for the first time. This
serves to remind you to change the disk
every month (approx. 30 brewing cycles).
To change the disk, remove the used disk,
insert new disk into the frame.
NOTE: For optimum results, use the water filtration
system with a permanent filter.
2. Rinse the water filter in fresh water before first use.
1 level tablespoon (tbsp)
9 Tbsp.
6.5 Tbsp.
Use more or less coffee to
4.5 Tbsp.
3 Tbsp.
water filtration
®
carbon-
®
Coffeemaker, please follow these
®
= 5 gr./0.17 oz.
1 cup = 5 fl. oz. of
brewed coffee
suit your taste.
Red
Indicator
®
11

Advertisement

Chapters

Table of Contents
loading

Table of Contents