ASSEMBLING AND PREPARING
Mounting on a wall
For proper ventilation, allow a clearance of 10 cm
on each side and from the wall. Detailed
instructions are available from your dealer, see the
optional Tilt Wall Mounting Bracket Installation and
If you intend to mount the Monitor set to a wall,
attach Wall mounting interface (optional parts) to
the back of the set.
When you install the Monitor set using a wall
mounting interface (optional parts), attach it
carefully so it will not drop.
If you use screw longer than standard, the moni-
tor might be damaged internally.
If you use improper screw, the product might be
damaged and drop from mounted position.
In this case, LG Electronics is not responsible
24MB37PM 24MB37PY 24MB37PV
(A x B)
100 x 100
M4 x L10
Wall Mount (A x B)
Disconnect the power cord first, and then
move or install the Monitor set. Otherwise
electric shock may occur.
If you install the Monitor set on a ceiling or
slanted wall, it may fall and result in severe
Use only an authorized LG wall mount
and contact the local dealer or qualified
Do not over tighten the screws as this may
cause damage to the Monitor set and void
Use only screws and wall mounts that
meet the VESA standard. Any damages
or injuries by misuse or using an improper
accessory are not covered by the warranty.
Screw length from outer surface of back
cover should be under 8mm.
Wall mount Pad
Wall mount Pad
Use the screws that are listed on the VESA
standard screw specifications.
The wall mount kit will include an installation
manual and necessary parts.
The wall mount bracket is optional. You can
obtain additional accessories from your local
The length of screws may differ depending
on the wall mount. Be sure to use the proper
For more information, refer to the
instructions supplied with the wall mount.