Setting up the Monitor set
Attaching the Stand Base
Place the Monitor set with the screen side
down on a flat and cushioned surface.
To protect the screen from scratches, cover
the surface with a soft cloth.
Check the position (at the front and rear) of
the stand body, then mount the stand base on
the stand body as shown in the figure.
Using a coin, turn the screw clockwise to se-
cure the stand base.
ASSEMBLING AND PREPARING
Detaching the stand base
Place the monitor's screen face down.
To protect the screen from scratches, cover the
surface with a soft cloth.
Using a coin, turn the screw in the stand base
counterclockwise. Detach the stand base from
the stand body.
The components appearing in the illustra-
tions may look different from the actual prod-
Do not carry the monitor upside-down as this
may cause it to fall off its stand, resulting in
damage or injury.
To avoid damaging the screen when lifting
or moving the monitor, only hold the stand or
the plastic cover. This avoids putting unnec-
essary pressure on the screen.
Only remove the tape and the locking pin
when the monitor is mounted on the stand
base and is in an upright position. Otherwise,
the stand body may protrude, which may
lead to injury.